MSX-ROM-Emulator

pdaehne·MSX-ROM-Emulator-PCB

MSX-ROM-Emulator PCB layout, top view — open source STM32 board by pdaehne

About the MSX-ROM-Emulator PCB

MSX-ROM-Emulator is an open source STM32 PCB design by pdaehne, published on GitHub under the CC-BY-NC-4.0 license. It is a 2-layer board measuring 99.9 × 65.2 mm, with 6 components from 6 distinct parts.

Its main chip is the MCUDev DevEBox STM32F407, from the STM32 family. Other key parts include the GY-PCM5102. By type, the board carries 2 modules, 2 switches, 1 connector and 1 diode.

It belongs with the retro computing and audio designs in this gallery.

From the project

KiCad project and Gerber files for a PCB for the MSX ROM and Floppy Emulator

This repository contains the KiCad project and Gerber files for a MSX cartridge that can emulate different kinds of MSX cartridges (with or without mappers) as well as a floppy drive controller. You simply put ROM and DSK images onto a MicroSD card, stick that card into the cartridge, switch on the MSX computer and select an image using a menu running on the computer. It is based on a cheap STM32F407 board and easy to solder. The corresponding firmware for the STM32F407 is available in the following GitHub repository:

MSX-ROM-Emulator, from the project README
From the project README

Main components on the MSX-ROM-Emulator

GY-PCM5102MCUDev DevEBox STM32F407

MSX-ROM-Emulator bill of materials (BOM)

6 components, 6 distinct parts.

QtyPartRefs
1
GY-PCM5102
A1
1
MCUDev DevEBox STM32F407
A2
1
MSX Cartridge
J1
1
Next
SW1
1
Prev
SW2
1
1N5817
D1

MSX-ROM-Emulator design files

The KiCad project lives in the pdaehne/MSX-ROM-Emulator-PCB repository on GitHub; these links point at the commit this page was built from.

MSX-ROM-Emulator: common questions

What microcontroller does the MSX-ROM-Emulator use?

The MSX-ROM-Emulator is built around the MCUDev DevEBox STM32F407, from the STM32 family.

How big is the MSX-ROM-Emulator PCB?

The MSX-ROM-Emulator measures 99.9 × 65.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the MSX-ROM-Emulator?

6 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the MSX-ROM-Emulator design files?

From the pdaehne/MSX-ROM-Emulator-PCB repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the MSX-ROM-Emulator design in my own project?

It is published under CC-BY-NC-4.0, which limits how it may be reused; read the license before building on it.

Can I test firmware for the MSX-ROM-Emulator without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards