HardLabs

Teensybig oled

pdp7·teensy-big-oled

Teensybig oled PCB layout, top view — open source NXP board by pdp7

About the Teensybig oled PCB

Teensybig oled is an open source NXP PCB design by pdp7, published on GitHub under the CERN-OHL-1.2 license. It is a 2-layer board measuring 4.8 × 4.8 mm, with 13 components from 3 distinct parts.

Its main chip is the TEENSY-LC, from the NXP family.

It belongs with the displays & leds designs in this gallery.

From the project

Teensy LC with Adafruit 128x64 OLED

Note: Arduino sketch contains code written by Limor Fried & Kevin Townsend for Adafruit Industries and is covered by BSD license

Teensybig oled bill of materials (BOM)

13 components, 3 distinct parts.

QtyPartRefs
1
TEENSY-LC
J1
1
OLED_128x64
J2
11
CAPSENSE_CIRCLE
CAP0, CAP1, CAP3, CAP4, CAP15, CAP16, CAP17, CAP18 +3

Teensybig oled design files

The KiCad project lives in the pdp7/teensy-big-oled repository on GitHub; these links point at the commit this page was built from.

Teensybig oled: common questions

What microcontroller does the Teensybig oled use?

The Teensybig oled is built around the TEENSY-LC, from the NXP family.

How big is the Teensybig oled PCB?

The Teensybig oled measures 4.8 × 4.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Teensybig oled?

13 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the Teensybig oled design files?

From the pdp7/teensy-big-oled repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Teensybig oled design in my own project?

Yes, under the terms of its CERN-OHL-1.2 license, which pdp7 chose for the repository.

Can I test firmware for the Teensybig oled without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug NXP firmware against it before you order a PCB.

Similar boards