VNA calibration board

PicoballoonLabs·Debug-Boards·RF VNA calibrator/RF_CAL.kicad_pcb

VNA calibration board layout, top view — open source board by PicoballoonLabs

About the VNA calibration board

VNA calibration board is an open source PCB design by PicoballoonLabs, published on GitHub under the MIT license. It is a 2-layer board measuring 17 × 10 mm, with 7 components from 2 distinct parts.

By type, the board carries 5 test points and 2 resistors.

From the project

Hardware designs for the integrated debug probe, debug adapter, flex debug cables and RF VNA calibrator

This repository contains the hardware designs for our integrated debug probe, debug adapter, flex debug cables and RF calibration board.

Flex debug cable: Flexible flat cable that connects a debugger to the low-profile debug connector on the target board. Debug Adapter: SWD debug adapter board that breaks the target debug connector out to a standard debug host, with its own target power supply. Integrated Debugger: Integrated debug probe for flashing and debugging target hardware over SWD, with a UART bridge and switchable target power. It is hardware compatible with the Black Magic Debug…

VNA calibration board bill of materials (BOM)

7 components, 2 distinct parts — part numbers from the project's BOM.

QtyPartRefs
5
MM8030-2610RK0
Coaxial Testpoint
TP1, TP2, TP3, TP4, TP5
2
RT0603FRD07100RL
100Ω
R1, R2

VNA calibration board design files

The KiCad project lives in the PicoballoonLabs/Debug-Boards repository on GitHub; these links point at the commit this page was built from.

VNA calibration board: common questions

How big is the VNA calibration board?

The VNA calibration board measures 17 × 10 mm, has 2 copper layers and is 1.09 mm thick.

How many components are on the VNA calibration board?

7 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the VNA calibration board design files?

From the PicoballoonLabs/Debug-Boards repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the VNA calibration board design in my own project?

Yes, under the terms of its MIT license, which PicoballoonLabs chose for the repository.

More boards in Debug-Boards