HardLabs

RetroPad-Assignment

prashantjnv172-alt·RetroPad-Assignment

This repository ships a schematic but no board layout.
Simulate this board

About the RetroPad-Assignment PCB

RetroPad-Assignment is an open source AVR/Arduino PCB design by prashantjnv172-alt, published on GitHub. It is a board, with 27 components from 10 distinct parts.

Its main chip is the ATtiny814-SS, from the AVR/Arduino family. By type, the board carries 11 resistors, 2 connectors, 1 IC, 1 diode and 1 capacitor.

It belongs with the retro computing designs in this gallery.

From the project

RetroPad: Schematic-to-SKiDL translation and netlist generation for a smart retro-controller

Main components on the RetroPad-Assignment

ATtiny814-SS

RetroPad-Assignment bill of materials (BOM)

27 components, 10 distinct parts.

QtyPartRefs
1
ATtiny814-SS
U1
1
DB9_Male
J1
1
Conn_01x06_Female
J2
9
—
BTN1, BTN2, BTN3, DOWN1, JUMP1, LEFT1, RAPID1, RIGHT1 +1
2
MountingHole_Pad
H1, H2
1
—
D1
1
0.1uF
C1
5
1K
R1, R2, R4, R5, R6
1
330
R3
5
0
R7, R8, R9, R10, R11

RetroPad-Assignment design files

The KiCad project lives in the prashantjnv172-alt/RetroPad-Assignment repository on GitHub; these links point at the commit this page was built from.

RetroPad-Assignment: common questions

What microcontroller does the RetroPad-Assignment use?

The RetroPad-Assignment is built around the ATtiny814-SS, from the AVR/Arduino family.

How many components are on the RetroPad-Assignment?

27 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the RetroPad-Assignment design files?

From the prashantjnv172-alt/RetroPad-Assignment repository on GitHub, which has a netlist; the links under Design files point to each one.

Can I use the RetroPad-Assignment design in my own project?

The repository has no license, so all rights stay with prashantjnv172-alt. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the RetroPad-Assignment without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards