HardLabs

My first project

q04ti·my-first-project·hardware/kicad/Starbie.kicad_sch

This repository ships a schematic but no board layout.

About the My first project PCB

My first project is an open source ESP32 PCB design by q04ti, published on GitHub under the MIT license. It is a board, with 1 components from 1 distinct parts.

Its main chip is the ESP32-C3 USB-C development board, from the ESP32 family.

From the project

This directory will contain the KiCad project after the component variants and electrical requirements are verified.

This directory will contain the KiCad project after the component variants and electrical requirements are verified.

The schematic/, pcb/, and libraries/ directories are intentionally empty. No fake .kicadsch or .kicadpcb files are created.

Main components on the My first project

ESP32-C3 USB-C development board

My first project bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-C3 USB-C development board
Seeed Studio
U1

My first project design files

The KiCad project lives in the q04ti/my-first-project repository on GitHub; these links point at the commit this page was built from.

My first project: common questions

What microcontroller does the My first project use?

The My first project is built around the ESP32-C3 USB-C development board, from the ESP32 family.

How many components are on the My first project?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the My first project design files?

From the q04ti/my-first-project repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.

Can I use the My first project design in my own project?

Yes, under the terms of its MIT license, which q04ti chose for the repository.

Can I test firmware for the My first project without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards