FPGA-MCU

RajmohanSriram·FPGA-MCU

This repository ships a schematic but no board layout.

About the FPGA-MCU PCB

FPGA-MCU is an open source FPGA PCB design by RajmohanSriram, published on GitHub. It is a board, with 6 components from 5 distinct parts.

Its main chip is the Untitled, from the FPGA family. By type, the board carries 3 resistors, 1 IC, 1 crystal and 1 capacitor.

From the project

Custom embedded platform with MCU and FPGA

FPGA-MCU bill of materials (BOM)

6 components, 5 distinct parts.

QtyPartRefs
1
—
U13_1
1
ASE-50MHz
Y4
1
100n
C77
2
10K
R10, R11
1
1K
R12

FPGA-MCU design files

The KiCad project lives in the RajmohanSriram/FPGA-MCU repository on GitHub; these links point at the commit this page was built from.

FPGA-MCU: common questions

What microcontroller does the FPGA-MCU use?

The FPGA-MCU is built around the Untitled, from the FPGA family.

How many components are on the FPGA-MCU?

6 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the FPGA-MCU design files?

From the RajmohanSriram/FPGA-MCU repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the FPGA-MCU design in my own project?

The repository has no license, so all rights stay with RajmohanSriram. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the FPGA-MCU without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug FPGA firmware against it before you order a PCB.

Similar boards