Open esc

rmingon·open-esc·hardware/Open-esc.kicad_pcb

Open esc PCB layout, top view — open source AVR/Arduino board by rmingon

About the Open esc PCB

Open esc is an open source AVR/Arduino PCB design by rmingon, published on GitHub. It is a 2-layer board measuring 56.8 × 19 mm, with 28 components from 8 distinct parts.

Its main chip is the ATmega88PA-A, from the AVR/Arduino family. Other key parts include the AMS1117-3.3. By type, the board carries 12 resistors, 7 capacitors, 6 transistors, 2 ICs and 1 connector.

It belongs with the robotics & motion and usb & debug tools designs in this gallery.

From the project

Open-Source 3-Phase Sensorless ESC Firmware

This is an open-source firmware for controlling 3-phase sensorless BLDC motors using an ATmega88PA microcontroller running at 8 MHz (internal oscillator). It is designed for small electric vehicles, drones, robotics, and DIY ESC applications. The design uses 6 MOSFETs in a three-phase bridge configuration and includes back-EMF sensing for sensorless commutation.

Open esc, from the project README
From the project README

Main components on the Open esc

Open esc bill of materials (BOM)

28 components, 8 distinct parts.

QtyPartRefs
1
ATmega88PA-A
U1
1
AMS1117-3.3
U2
3
AO3401A
Q1, Q3, Q5
3
IRLML0030
Q2, Q4, Q6
1
AVR-ISP-6
J1
7
C
C1, C2, C3, C4, C5, C6, C7
9
R_Small
R1, R2, R3, R4, R5, R6, R7, R8 +1
3
33K
R10, R11, R12

Open esc design files

The KiCad project lives in the rmingon/open-esc repository on GitHub; these links point at the commit this page was built from.

Open esc: common questions

What microcontroller does the Open esc use?

The Open esc is built around the ATmega88PA-A, from the AVR/Arduino family.

How big is the Open esc PCB?

The Open esc measures 56.8 × 19 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Open esc?

28 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Open esc design files?

From the rmingon/open-esc repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Open esc design in my own project?

The repository has no license, so all rights stay with rmingon. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Open esc without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards