Cablebot power
About the Cablebot power PCB
Cablebot power is an open source PCB design by romi, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 80 × 21.7 mm, with 12 components from 11 distinct parts.
Other key parts include the OKI-78SR-5_1.5-W36-C. By type, the board carries 6 connectors, 2 fuses, 1 IC, 1 switch, 1 diode and 1 resistor.
From the project
Just one set is needed either small or big, depending on cable tension (big is better for high tension).
Main components on the Cablebot power
Cablebot power bill of materials (BOM)
12 components, 11 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | OKI-78SR-5_1.5-W36-C | Converter_DCDC_Murata_OKI-78SR_Horizontal | U1 |
| 1 | BATTERY | TerminalBlock_Altech_AK300-2_P5.00mm | J1 |
| 1 | POWER_ODRIVE | TerminalBlock_Altech_AK300-2_P5.00mm | J2 |
| 1 | CHARGING_STATION | TerminalBlock_Altech_AK300-2_P5.00mm | J3 |
| 2 | OUTPUT | TerminalBlock_Phoenix_PT-1,5-2-3.5-H_1x02_P3.50mm_Horizontal | J4, J5 |
| 1 | CAMERA MODULE | TerminalBlock_Phoenix_PT-1,5-2-3.5-H_1x02_P3.50mm_Horizontal | J6 |
| 1 | Fuse | Fuseholder_Littelfuse_Nano2_154x | F1 |
| 1 | Fuse | GENERIC_4010_10228 | F2 |
| 1 | SW_SPDT | TerminalBlock_Altech_AK300-2_P5.00mm | SW1 |
| 1 | RED | fab-LED1206FAB | D1 |
| 1 | 1kΩ | fab-R1206FAB | R1 |
Cablebot power design files
The KiCad project lives in the romi/romi-cablebot repository on GitHub; these links point at the commit this page was built from.
Cablebot power: common questions
How big is the Cablebot power PCB?
The Cablebot power measures 80 × 21.7 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Cablebot power?
12 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Cablebot power design files?
From the romi/romi-cablebot repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.
Can I use the Cablebot power design in my own project?
Yes, under the terms of its GPL-3.0 license, which romi chose for the repository.
