Robot Arm
Said-Soufiyane·Robot_Arm_·electronics/pcb/source/roboarm.kicad_pcb
About the Robot Arm PCB
Robot Arm is an open source PCB design by Said-Soufiyane, published on GitHub. It is a 2-layer board measuring 147 × 119 mm, with 4 components from 1 distinct parts.
It belongs with the robotics & motion designs in this gallery.
From the project
A table-mountable 6-axis desktop robot arm project focused on being publishable, reproducible, and upgradeable. Target is a real 2.0 kg payload using COTS metal planetary gearboxes on the high-torque joints, with careful bearing design so gearboxes are not used as structural supp
A table-mountable 6-axis desktop robot arm project focused on being publishable, reproducible, and upgradeable. Target is a real 2.0 kg payload using COTS metal planetary gearboxes on the high-torque joints, with careful bearing design so gearboxes are not used as structural supports.
Mechanical rule (non-negotiable): Gearboxes are not structural bearings. Each joint uses a bearing stack so loads go through bearings, not gearbox shafts.

Robot Arm bill of materials (BOM)
4 components, 1 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 4 | . | PinSocket_1x08_P2.54mm_Vertical | 1, enable1, enable2, enable 1 |
Robot Arm design files
The KiCad project lives in the Said-Soufiyane/Robot_Arm_ repository on GitHub; these links point at the commit this page was built from.
Robot Arm: common questions
How big is the Robot Arm PCB?
The Robot Arm measures 147 × 119 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Robot Arm?
4 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Robot Arm design files?
From the Said-Soufiyane/Robot_Arm_ repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Robot Arm design in my own project?
The repository has no license, so all rights stay with Said-Soufiyane. Use it as a reference, and ask the author before reusing the design.
Similar boards
Stack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7kCube batteryboard
willem-pennings
95 × 95 mm4 parts2LGPL-3.01.1kTrollerv2
rene-dev
100 × 75 mm33 parts4LGPL-3.0979Powerstep
rene-dev
95.2 × 71.5 mm28 parts4LGPL-3.097911ua
rene-dev
57.3 × 19 mm26 parts2LGPL-3.0979Diff driver
rene-dev
32 × 22 mm14 parts2LGPL-3.0979