Attiny85-sensor node

samils2·attiny85-sensor-node·Hardware/capstone.kicad_pcb

Attiny85-sensor node PCB layout, top view — open source AVR/Arduino board by samils2

About the Attiny85-sensor node PCB

Attiny85-sensor node is an open source AVR/Arduino PCB design by samils2, published on GitHub. It is a 2-layer board measuring 174.5 × 87.5 mm, with 11 components from 10 distinct parts.

Its main chip is the ATtiny85-20P, from the AVR/Arduino family. By type, the board carries 3 resistors, 2 connectors, 2 diodes, 2 capacitors and 1 IC.

It belongs with the sensors designs in this gallery.

From the project

A small through-hole PCB built around an ATtiny85 that reads a potentiometer with the on-chip ADC and drives an LED output. I designed it in KiCad as the capstone of a self-directed electronics curriculum covering circuit fundamentals, digital logic, and PCB design workflow.

A small through-hole PCB built around an ATtiny85 that reads a potentiometer with the on-chip ADC and drives an LED output. I designed it in KiCad as the capstone of a self-directed electronics curriculum covering circuit fundamentals, digital logic, and PCB design workflow.

- [x] Schematic complete, ERC clean - [x] PCB layout complete, DRC clean - [x] Gerbers exported and ready for fabrication (JLCPCB)

Main components on the Attiny85-sensor node

Attiny85-sensor node bill of materials (BOM)

11 components, 10 distinct parts.

QtyPartRefs
1
ATtiny85-20P
U1
1
Conn_01x02_Pin
J1
1
Conn_02x03_Counter_Clockwise
J2
1
Potentiometer
RV1
2
LED
D1, D2
1
100nF
C1
1
10μF
C2
1
330Ω
R1
1
10kΩ
R2
1
1kΩ
R3

Attiny85-sensor node design files

The KiCad project lives in the samils2/attiny85-sensor-node repository on GitHub; these links point at the commit this page was built from.

Attiny85-sensor node: common questions

What microcontroller does the Attiny85-sensor node use?

The Attiny85-sensor node is built around the ATtiny85-20P, from the AVR/Arduino family.

How big is the Attiny85-sensor node PCB?

The Attiny85-sensor node measures 174.5 × 87.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Attiny85-sensor node?

11 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Attiny85-sensor node design files?

From the samils2/attiny85-sensor-node repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Attiny85-sensor node design in my own project?

The repository has no license, so all rights stay with samils2. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Attiny85-sensor node without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards