43 open source boards using the ATtiny85-20P

Real designs built with the ATtiny85-20P, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

43 boardsClear filters|Most starred

How designs wire the ATtiny85-20P

Read from the KiCad layouts of 40 open source designs, one per repository: what each pin of the ATtiny85-20P connects to, and the resistors, capacitors and other passives placed on it.

GNDpin 4Connected to: GND 93%
PB1pin 6Connected to: A connector 35%
  • Series resistor on 30% · 220 Ω (3), 470 Ω (2), 1 kΩ (2)
VCCpin 8Connected to: 5V 80% · a signal 20%

5 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Repeater v2 by plusvic, Playground 68030 Mk I by thorpej, Attiny85-dev board by tomasr8 and Tiny85fancontrol by Colahall.

The ATtiny85-20P in open source designs

The gallery holds 43 open source boards using the ATtiny85-20P from 40 GitHub repositories; a typical one measures about 56 × 46 mm and carries around 15 components.

95% are two-layer designs, the rest use four layers or more, and 33% carry an open source license.

The most starred is Repeater v2 by plusvic.

Parts used alongside the ATtiny85-20P

Microcontrollers on boards using the ATtiny85-20P

ATtiny85-20P: common questions

Where can I find a ATtiny85-20P reference design?

Each of the 43 boards on this page is a real design using the ATtiny85-20P. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What parts are used alongside the ATtiny85-20P?

The 27C512, AMS1117-3.3, LM7805_TO220, 74LS74 and GAL22V10 appear in the most repositories here.

Which microcontrollers do boards using the ATtiny85-20P use?

Most are built on AVR/Arduino (42) and STM32 (1).

How big is a typical board using the ATtiny85-20P?

The median is 56 × 46 mm, and 95% are two-layer designs.

What is the most popular open source board using the ATtiny85-20P?

By GitHub stars, Repeater v2 by plusvic, with 93 stars.

Can I simulate one of these boards using the ATtiny85-20P before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part