Encoder
sbarisic·MagMouse·hardware/encoder/Encoder.kicad_pcb
About the Encoder PCB
Encoder is an open source PCB design by sbarisic, published on GitHub under the Custom license license. It is a 4-layer board measuring 14 × 18 mm, with 3 components from 3 distinct parts.
Other key parts include the MA735GGU-P. By type, the board carries 1 IC, 1 connector and 1 capacitor.
From the project
Open source hall-effect based mouse - no mechanical contacts - no failure points
J7 now uses eight plated solder holes in a 2×4 array on 2.54 mm pitch, 0.8 mm nominal holes / 1.8 mm pads. All eight signals, including three grounds, remain connected to Main J6 by the 150 mm AWG28 harness. There is no JST purchase or paste on these lands. Sensor position and board outline are preserved; local termination routing is updated. See the wire map and printable carrier. The historical connector description below is superseded for Rev-A.
Main components on the Encoder
Encoder bill of materials (BOM)
3 components, 3 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | MA735GGU-P Monolithic Power Systems | MPS_UTQFN14_2x2 | U27 |
| 1 | Soldered wires Signal_2x04 | Wire_Signal_2x04_P2.54mm | J7 |
| 1 | CL10A105KB8NNNC 1uF/50V Samsung Electro-Mechanics | C_0603_1608Metric | C62 |
Encoder design files
The KiCad project lives in the sbarisic/MagMouse repository on GitHub; these links point at the commit this page was built from.
Encoder: common questions
How big is the Encoder PCB?
The Encoder measures 14 × 18 mm, has 4 copper layers and is 1.578 mm thick.
How many components are on the Encoder?
3 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Encoder design files?
From the sbarisic/MagMouse repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Encoder design in my own project?
It is published under Custom license, which limits how it may be reused; read the license before building on it.
More boards in MagMouse
ESP32
Panel
sbarisic
151 × 139 mm292 parts4LCustom license2ESP32
MagMouse
sbarisic
60 × 95 mm273 parts4LCustom license2ESP32
Main
sbarisic
80 × 125 mm207 parts4LCustom license2ESP32
Lower
sbarisic
70 × 100 mm92 parts2LCustom license2Wheel
sbarisic
55 × 60 mm82 parts4LCustom license2Upper
sbarisic
70 × 100 mm81 parts2LCustom license2