Santroller

SolidElectronics·santroller-pcb

Santroller PCB layout, top view — open source RP2040/RP2350 board by SolidElectronics

About the Santroller PCB

Santroller is an open source RP2040/RP2350 PCB design by SolidElectronics, published on GitHub. It is a 2-layer board measuring 50 × 30 mm, with 13 components from 7 distinct parts.

Its main chip is the RP2040-Zero, from the RP2040/RP2350 family. By type, the board carries 5 resistors, 4 diodes, 2 connectors and 1 switch.

It belongs with the test & measurement designs in this gallery.

From the project

PCB for Santroller USB Rock Band instrument adapters

Santroller bill of materials (BOM)

13 components, 7 distinct parts.

QtyPartRefs
1
USB_A
J1
1
EXT
J3
1
RP2040-Zero
RZ1
1
Mode
SW1
4
LED
D1, D2, D3, D4
1
100
R1
4
220
R2, R3, R4, R5

Santroller design files

The KiCad project lives in the SolidElectronics/santroller-pcb repository on GitHub; these links point at the commit this page was built from.

Santroller: common questions

What microcontroller does the Santroller use?

The Santroller is built around the RP2040-Zero, from the RP2040/RP2350 family.

How big is the Santroller PCB?

The Santroller measures 50 × 30 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Santroller?

13 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Santroller design files?

From the SolidElectronics/santroller-pcb repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Santroller design in my own project?

The repository has no license, so all rights stay with SolidElectronics. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Santroller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards