First-Keyboard attempt

StarLizard·First-Keyboard-attempt

First-Keyboard attempt PCB layout, top view — open source AVR/Arduino board by StarLizard

About the First-Keyboard attempt PCB

First-Keyboard attempt is an open source AVR/Arduino PCB design by StarLizard, published on GitHub. It is a 2-layer board measuring 237.3 × 107.8 mm, with 139 components from 14 distinct parts.

Its main chip is the ATmega32U4-A, from the AVR/Arduino family. By type, the board carries 60 diodes, 7 capacitors, 6 resistors, 3 connectors, 1 IC and 1 crystal.

It belongs with the keyboards designs in this gallery.

From the project

first attempt at a BT keyboard after not understanding electrical engineering.

Trying to design my own Bluetooth Keyboard pcb with Hotswap MX Switches

Main components on the First-Keyboard attempt

First-Keyboard attempt bill of materials (BOM)

139 components, 14 distinct parts.

QtyPartRefs
1
ATmega32U4-A
U2
1
Crystal_GND24_Small
Y1
1
USB_C_Receptacle
J1
2
Conn_01x17_Socket
J2, J3
60
MX_SW_HS
MX1, MX2, MX3, MX4, MX5, MX6, MX7, MX8 +52
1
SW_Push
SW1
60
D_Small
D1, D2, D3, D4, D5, D6, D7, D8 +52
1
1uF
C1
3
0.1uF
C2, C3, C4
1
10uF
C5
2
22pF
C6, C7
2
10k
R1, R4
2
22
R2, R3
2
5.1k
R5, R6

First-Keyboard attempt design files

The KiCad project lives in the StarLizard/First-Keyboard-attempt repository on GitHub; these links point at the commit this page was built from.

First-Keyboard attempt: common questions

What microcontroller does the First-Keyboard attempt use?

The First-Keyboard attempt is built around the ATmega32U4-A, from the AVR/Arduino family.

How big is the First-Keyboard attempt PCB?

The First-Keyboard attempt measures 237.3 × 107.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the First-Keyboard attempt?

139 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the First-Keyboard attempt design files?

From the StarLizard/First-Keyboard-attempt repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the First-Keyboard attempt design in my own project?

The repository has no license, so all rights stay with StarLizard. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the First-Keyboard attempt without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards