US Board1

team5985·Ultrasonics·Controller/v01.00/Hardware/US_Board1.kicad_pcb

US Board1 PCB layout, top view — open source AVR/Arduino board by team5985

About the US Board1 PCB

US Board1 is an open source AVR/Arduino PCB design by team5985, published on GitHub. It is a 2-layer board measuring 50 × 50 mm, with 7 components from 5 distinct parts.

Its main chip is the ATtiny2313-20PU, from the AVR/Arduino family. By type, the board carries 2 capacitors and 1 IC.

From the project

Ultrasonic hardware and software

This contains the design files for the ultrasonics circuit boards, as well as the software for the microcontroller.

* Hardware These are the project files from KiCAD and include the circuit diagramme, netlist, and PCB layout. The Gerber directory contains the final output that was sent to the PCB manufacturer to have the boards made. This should be openable as a project from within KiCAD.

Main components on the US Board1

US Board1 bill of materials (BOM)

7 components, 5 distinct parts.

QtyPartRefs
1
ATtiny2313-20PU
U1
1
Crystal
4MHz
2
R
200R1, 200R2
1
Conn_01x04_Male
I2C
2
C
C1, C2

US Board1 design files

The KiCad project lives in the team5985/Ultrasonics repository on GitHub; these links point at the commit this page was built from.

US Board1: common questions

What microcontroller does the US Board1 use?

The US Board1 is built around the ATtiny2313-20PU, from the AVR/Arduino family.

How big is the US Board1 PCB?

The US Board1 measures 50 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the US Board1?

7 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the US Board1 design files?

From the team5985/Ultrasonics repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the US Board1 design in my own project?

The repository has no license, so all rights stay with team5985. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the US Board1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in Ultrasonics

Similar boards