Timegrapher PreAmp

thisoldscot·Timegrapher_PreAmp

Timegrapher PreAmp PCB layout, top view — open source board by thisoldscot

About the Timegrapher PreAmp PCB

Timegrapher PreAmp is an open source PCB design by thisoldscot, published on GitHub under the CC-BY-NC-4.0 license. It is a 2-layer board measuring 36 × 28 mm, with 12 components from 9 distinct parts.

Other key parts include the MCP602-I/P. By type, the board carries 6 resistors, 3 capacitors, 2 diodes and 1 IC.

It belongs with the audio, test & measurement and dev boards & breakouts designs in this gallery.

From the project

Through-hole piezo preamplifier board for the Timegrapher Studio - conditions the faint escapement signal for the I2S ADC. KiCad.

Timegrapher PreAmp is the through-hole piezo preamplifier board for the Timegrapher Studio wristwatch timegrapher. It conditions the faint escapement signal from the piezo pickup and feeds the I²S ADC on the carrier HAT. This is the hand-solderable variant; an SMD version lives in Timegrapher_PreAmpSMD. Designed in KiCad. See DESIGN.md and BOM.md.

This repository contains the KiCad design and production files:

Timegrapher PreAmp, from the project README
From the project README

Main components on the Timegrapher PreAmp

MCP602-I/P

Timegrapher PreAmp bill of materials (BOM)

12 components, 9 distinct parts.

QtyPartRefs
1
MCP602-I/P
U1
2
1N4148
D1, D2
1
100pF
C1
1
10uF
C3
1
100nF
C4
1
4.7M
R1
3
10k
R3, R4, R6
1
100k
R5
1
1k
R7

Timegrapher PreAmp design files

The KiCad project lives in the thisoldscot/Timegrapher_PreAmp repository on GitHub; these links point at the commit this page was built from.

Timegrapher PreAmp: common questions

How big is the Timegrapher PreAmp PCB?

The Timegrapher PreAmp measures 36 × 28 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Timegrapher PreAmp?

12 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Timegrapher PreAmp design files?

From the thisoldscot/Timegrapher_PreAmp repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Timegrapher PreAmp design in my own project?

It is published under CC-BY-NC-4.0, which limits how it may be reused; read the license before building on it.

Similar boards