EavesDrum Connector

tobigun·EavesDrum·schematics/connector/eavesdrum_connector.kicad_pcb

EavesDrum Connector PCB layout, top view — open source board by tobigun

About the EavesDrum Connector PCB

EavesDrum Connector is an open source PCB design by tobigun, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 100 × 100 mm, with 21 components from 5 distinct parts.

By type, the board carries 13 connectors and 8 jumpers.

It belongs with the audio and wearables designs in this gallery.

From the project

EavesDrum is an e-drum trigger module project, designed for musicians and makers. It allows you to connect drum pads or piezo triggers and converts their signals into MIDI events.

- Welcome to EavesDrum! - Downloads - EavesDrum Trigger Module - Features - Before You Start: Is EavesDrum What You Need? - Getting Started - Build Your Own EavesDrum Trigger Module - Use the Reference Design - PCB Ordering and Assembly - Connector Harness - Connector Module - Build your own adapter - Wiring the Single Pad Connectors - Make Your Own Design - How the Circuit Works - Over-Voltage Protection - Voltage Divider / DC Voltage Offset Generator - Example - Configuration - Calibration - Settings - Generic Settings - Pedal Settings - Apply Presets - Mappings - Apply a Whole…

EavesDrum Connector, from the project README
From the project README

EavesDrum Connector bill of materials (BOM)

21 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
11
AudioJack3_Dual_Ground_Switch
J1, J2, J3, J4, J5, J6, J7, J8 +3
1
Conn_01x03_Pin
J13
1
Conn_01x07_Pin
J14
6
Jumper_2_Small_Open
JP1, JP2, JP3, JP4, JP5, JP6
2
Jumper_3_Open
JP7, JP8

EavesDrum Connector design files

The KiCad project lives in the tobigun/EavesDrum repository on GitHub; these links point at the commit this page was built from.

EavesDrum Connector: common questions

How big is the EavesDrum Connector PCB?

The EavesDrum Connector measures 100 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the EavesDrum Connector?

21 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the EavesDrum Connector design files?

From the tobigun/EavesDrum repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the EavesDrum Connector design in my own project?

Yes, under the terms of its GPL-3.0 license, which tobigun chose for the repository.

More boards in EavesDrum

Similar boards