SWIPE-STACK-GLOVE

vclagudu·SWIPE-STACK·PCB/swipe-stack-glove/swipe-stack-glove.kicad_pcb

SWIPE-STACK-GLOVE PCB layout, top view — open source STM32 board by vclagudu

About the SWIPE-STACK-GLOVE PCB

SWIPE-STACK-GLOVE is an open source STM32 PCB design by vclagudu, published on GitHub. It is a 2-layer board measuring 38.1 × 53.3 mm, with 42 components from 20 distinct parts.

Its main chip is the STM32F091RCTx, from the STM32 family. Other key parts include the BNO085, MAX7375AXR805 and HM-19. By type, the board carries 14 capacitors, 10 resistors, 5 connectors, 4 ICs, 4 switches and 4 diodes.

From the project

Senior Design Projrct

Main components on the SWIPE-STACK-GLOVE

SWIPE-STACK-GLOVE bill of materials (BOM)

42 components, 20 distinct parts.

QtyPartRefs
1
STM32F091RCTx
U1
1
BNO085
U2
1
MAX7375AXR805
U3
1
HM-19
U4
1
Conn_01x05_Socket
J2
3
Conn_01x01_Pin
J3, J4, J5
1
Conn_01x04
J6
4
SW_Push
SW1, SW2, SW3, SW4
1
ECX-.327-CDX-1293
XTAL1
2
green
D1, D2
1
red
D3
1
blue
D4
11
0.1uF
C1, C2, C3, C6, C8, C9, C10, C11 +3
2
22pF
C4, C5
1
10uF
C7
2
100k
R1, R6
3
1k
R2, R3, R7
1
470
R4
3
1k
R9, R11, R12
1
510
R10

SWIPE-STACK-GLOVE design files

The KiCad project lives in the vclagudu/SWIPE-STACK repository on GitHub; these links point at the commit this page was built from.

SWIPE-STACK-GLOVE: common questions

What microcontroller does the SWIPE-STACK-GLOVE use?

The SWIPE-STACK-GLOVE is built around the STM32F091RCTx, from the STM32 family.

How big is the SWIPE-STACK-GLOVE PCB?

The SWIPE-STACK-GLOVE measures 38.1 × 53.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the SWIPE-STACK-GLOVE?

42 components, from 20 distinct parts. The full bill of materials is listed on this page.

Where can I download the SWIPE-STACK-GLOVE design files?

From the vclagudu/SWIPE-STACK repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the SWIPE-STACK-GLOVE design in my own project?

The repository has no license, so all rights stay with vclagudu. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the SWIPE-STACK-GLOVE without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in SWIPE-STACK

Similar boards