HardLabs

Creactif electroLAB

Vincent-Stragier·Creactif-electroLAB·Séance_ATtiny85/Projet_Kicad/ATtiny85_Arduino_programmer_v1.0.1/ATtiny85_Arduino_programmer.kicad_pcb

Creactif electroLAB PCB layout, top view — open source AVR/Arduino board by Vincent-Stragier

About the Creactif electroLAB PCB

Creactif electroLAB is an open source AVR/Arduino PCB design by Vincent-Stragier, published on GitHub under the MIT license. It is a 2-layer board measuring 57.6 × 53.9 mm, with 18 components from 12 distinct parts.

Its main chip is the ATtiny85-20PU, from the AVR/Arduino family. By type, the board carries 4 jumpers, 3 connectors, 3 diodes, 3 resistors, 2 switches and 1 IC.

It belongs with the usb & debug tools designs in this gallery.

From the project

Documents utilisés lors des séances Créactif! dispensées par l'electroLAB.

[v1.0.0] - Shield fonctionnel pour programmer l'ATtiny85 avec une carte Arduino Uno

[v1.0.1] - Changement du silkscreen de l'empreinte du shield (suppression du contour)

Main components on the Creactif electroLAB

ATtiny85-20PU

Creactif electroLAB bill of materials (BOM)

18 components, 12 distinct parts.

QtyPartRefs
1
ATtiny85-20PU
U1
1
Conn_02x03_Counter_Clockwise
J1
2
Conn_01x04_Female
J2, J3
4
Jumper
JP1, JP2, JP3, JP4
1
ARDUINO_SHIELD
SHIELD1
1
SW_Push_Open
SW1
1
SW_Push_SPDT
SW2
1
LED-ORANGE
D1
1
LED-RED
D2
1
LED-GREEN
D3
1
10µ
C1
3
220
R1, R2, R3

Creactif electroLAB design files

The KiCad project lives in the Vincent-Stragier/Creactif-electroLAB repository on GitHub; these links point at the commit this page was built from.

Creactif electroLAB: common questions

What microcontroller does the Creactif electroLAB use?

The Creactif electroLAB is built around the ATtiny85-20PU, from the AVR/Arduino family.

How big is the Creactif electroLAB PCB?

The Creactif electroLAB measures 57.6 × 53.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Creactif electroLAB?

18 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the Creactif electroLAB design files?

From the Vincent-Stragier/Creactif-electroLAB repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Creactif electroLAB design in my own project?

Yes, under the terms of its MIT license, which Vincent-Stragier chose for the repository.

Can I test firmware for the Creactif electroLAB without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards