Non magic encoder

VX-wiki·non-magic-encoder·hardware/kicad/non-magic-encoder-r1.kicad_pcb

Non magic encoder PCB layout, top view — open source board by VX-wiki

About the Non magic encoder PCB

Non magic encoder is an open source PCB design by VX-wiki, published on GitHub under the CC-BY-NC-4.0 license. It is a 2-layer board measuring 46.4 × 27 mm, with 19 components from 12 distinct parts.

Other key parts include the MT6835 and AM26C31QDR. By type, the board carries 7 resistors, 4 capacitors, 3 ICs, 2 diodes, 1 transistor and 1 connector.

It belongs with the robotics & motion designs in this gallery.

From the project

A non-magic magnetic encoder for Vectrix VX-1 maxi scooter motor controller

Non-Magic R1 is community-beta DIY hardware that is still actively under test.

It has been bench-tested and road-tested on the author's single Vectrix VX-1 and, in those limited conditions, has shown no measurable power, efficiency, current, or heat penalty versus the OEM optical encoder. That is the whole of the evidence so far: one bike, a modest number of hours, one rider. It is a small-batch maker project, not a mass-produced, durability-qualified, or independently certified vehicle component.

Non magic encoder, from the project README
From the project README

Main components on the Non magic encoder

MT6835AM26C31QDR

Non magic encoder bill of materials (BOM)

19 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
MT6835
U1
2
AM26C31QDR
U7, U8
1
2N7002
Q1
1
CONN_02X07_ODD_EVEN
Conn_02x07_Odd_Even
J1
1
C318884
CAL
SW1
1
SMAJ5.0A
D1
1
LED
D4
1
10U
10u
C2
3
100N
100n
C6, C7, C8
5
100K
100k
R6, R7, R8, R9, R12
1
100R
R10
1
C21190
1k 0603
R11

Non magic encoder design files

The KiCad project lives in the VX-wiki/non-magic-encoder repository on GitHub; these links point at the commit this page was built from.

Non magic encoder: common questions

How big is the Non magic encoder PCB?

The Non magic encoder measures 46.4 × 27 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Non magic encoder?

19 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Non magic encoder design files?

From the VX-wiki/non-magic-encoder repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Non magic encoder design in my own project?

It is published under CC-BY-NC-4.0, which limits how it may be reused; read the license before building on it.

Similar boards