HardLabs

Thermal io link condition sensor

w1ne·thermal-io-link-condition-sensor·hardware/schematic.kicad_sch

This repository ships a schematic but no board layout.

About the Thermal io link condition sensor PCB

Thermal io link condition sensor is an open source PCB design by w1ne, published on GitHub under the MIT license. It is a board, with 1 components from 1 distinct parts.

It belongs with the sensors designs in this gallery.

From the project

An MLX90640 thermal camera and an ESP32-C3 classify a machine's thermal fingerprint on-edge and report a STABLE/WARN/FAULT verdict over IO-Link. The firmware is booted on the open LabWired engine and the page is verified only if the run passes its acceptance checks; Export to GitHub turns it into a self-verifying repo.

An MLX90640 thermal camera and an ESP32-C3 classify a machine's thermal fingerprint on-edge and report a STABLE/WARN/FAULT verdict over IO-Link. The firmware is booted on the open LabWired engine and the page is verified only if the run passes its acceptance checks; Export to GitHub turns it into a self-verifying repo.

- Continue in proto.cat — https://proto.cat/d/0622bc20 - Re-verify with LabWired — CI re-runs the build against the open LabWired engine on every push (downloads the pinned engine binary + chip descriptors, then labwired test). See .github/workflows/verify.yml.

Thermal io link condition sensor bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
M12 IO-LINK CONNECTOR
thermal-m12

Thermal io link condition sensor design files

The KiCad project lives in the w1ne/thermal-io-link-condition-sensor repository on GitHub; these links point at the commit this page was built from.

Thermal io link condition sensor: common questions

How many components are on the Thermal io link condition sensor?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Thermal io link condition sensor design files?

From the w1ne/thermal-io-link-condition-sensor repository on GitHub, which has the schematic, a netlist and the BOM; the links under Design files point to each one.

Can I use the Thermal io link condition sensor design in my own project?

Yes, under the terms of its MIT license, which w1ne chose for the repository.

Similar boards