AUV Controller

wangga03·Tugas-Akhir·Main-Board/AUV_Controller/AUV_Controller.kicad_pcb

AUV Controller PCB layout, top view — open source NXP board by wangga03

About the AUV Controller PCB

AUV Controller is an open source NXP PCB design by wangga03, published on GitHub. It is a 2-layer board measuring 100 × 100 mm, with 5 components from 2 distinct parts.

Its main chip is the TEENSY_4.1, from the NXP family. By type, the board carries 4 connectors and 1 module.

From the project

Berisi tentang board unbtuk AUV Halo test branch

Main components on the AUV Controller

AUV Controller bill of materials (BOM)

5 components, 2 distinct parts.

QtyPartRefs
1
TEENSY_4.1
A1
4
Conn_01x04_Pin
J1, J2, J3, J4

AUV Controller design files

The KiCad project lives in the wangga03/Tugas-Akhir repository on GitHub; these links point at the commit this page was built from.

AUV Controller: common questions

What microcontroller does the AUV Controller use?

The AUV Controller is built around the TEENSY_4.1, from the NXP family.

How big is the AUV Controller PCB?

The AUV Controller measures 100 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the AUV Controller?

5 components, from 2 distinct parts. The full bill of materials is listed on this page.

Where can I download the AUV Controller design files?

From the wangga03/Tugas-Akhir repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the AUV Controller design in my own project?

The repository has no license, so all rights stay with wangga03. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the AUV Controller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug NXP firmware against it before you order a PCB.

More boards in Tugas-Akhir

Similar boards