Pedal interceptor hardware

Wim426F·Pedal-interceptor-hardware

Pedal interceptor hardware PCB layout, top view — open source STM32 board by Wim426F

About the Pedal interceptor hardware PCB

Pedal interceptor hardware is an open source STM32 PCB design by Wim426F, published on GitHub. It is a 2-layer board measuring 40 × 50 mm, with 41 components from 19 distinct parts.

Its main chip is the STM32F205RET6, from the STM32 family. Other key parts include the MCP6002T-I/SN, TJA1042TK-3 and TPS73433DDCR. By type, the board carries 17 resistors, 14 capacitors, 4 ICs, 4 connectors, 1 crystal and 1 diode.

It belongs with the audio designs in this gallery.

Main components on the Pedal interceptor hardware

Pedal interceptor hardware bill of materials (BOM)

41 components, 19 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F205RET6
U1
1
MCP6002T-I/SN
U2
1
TJA1042TK-3
U3
1
TPS73433DDCR
U4
1
ABM8AIG-16.000MHZ-82Z-T
Y1
1
RJ45
J1
1
USB_C_RECEPTACLE_USB2.0_16P
USB_C_Receptacle_USB2.0_16P
J2
1
Pedal in
J4
1
Pedal out
J5
1
C2297
LED_GREEN
D1
8
100NF
100nF
C1, C3, C6, C7, C8, C9, C12, C14
1
4.7UF
4.7uF
C2
2
12PF
12pF
C4, C5
3
2.2UF
2.2uF
C10, C11, C13
8
10kΩ
R1, R6, R13, R14, R15, R16, R17, R18
1
220R
R2
2
5.1K
5.1k
R3, R4
2
22R
R7, R8
4
1kΩ
R9, R10, R11, R12

Pedal interceptor hardware design files

The KiCad project lives in the Wim426F/Pedal-interceptor-hardware repository on GitHub; these links point at the commit this page was built from.

Pedal interceptor hardware: common questions

What microcontroller does the Pedal interceptor hardware use?

The Pedal interceptor hardware is built around the STM32F205RET6, from the STM32 family.

How big is the Pedal interceptor hardware PCB?

The Pedal interceptor hardware measures 40 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pedal interceptor hardware?

41 components, from 19 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Pedal interceptor hardware design files?

From the Wim426F/Pedal-interceptor-hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Pedal interceptor hardware design in my own project?

The repository has no license, so all rights stay with Wim426F. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Pedal interceptor hardware without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards