DC-DC-Buck Down

YannickKoenig·DIY-Laboratory-Power-Supply·hardware/electrical/buck-converter/KiCAD/schaltung.kicad_pcb

DC-DC-Buck Down PCB layout, top view — open source board by YannickKoenig

About the DC-DC-Buck Down PCB

DC-DC-Buck Down is an open source PCB design by YannickKoenig, published on GitHub under the MIT license. It is a 2-layer board measuring 89 × 50 mm, with 10 components from 10 distinct parts.

Other key parts include the TC4427xOA. By type, the board carries 4 resistors, 2 capacitors, 1 IC, 1 transistor, 1 diode and 1 inductor.

It belongs with the power & battery, test & measurement and displays & leds designs in this gallery.

From the project

A simple, microcontroller-based PWM buck converter power supply, designed to provide precise voltage control and current measurement.

4. Connect the wiring: - Connect the Buck Converter PCB and the Frontend PCB (if used) using the following connections:

- Connect the output of the Buck Converter:

- Vout+` → Positive output terminal (e.g., banana plug).

- Vout-` → Negative output terminal (e.g., banana plug).

You can use banana plugs, terminal blocks, or any other suitable connectors for your output.

DC-DC-Buck Down, from the project README
From the project README

Main components on the DC-DC-Buck Down

DC-DC-Buck Down bill of materials (BOM)

10 components, 10 distinct parts.

QtyPartRefs
1
TC4427xOA
U1
1
IRLZ44N
Q1
1
SS34
D1
1
L
L1
1
1000µF
C1
1
1µF
C2
1
0.1 Ohm
R1
1
51k
R2
1
10k
R3
1
100k
R4_Bleed1

DC-DC-Buck Down design files

The KiCad project lives in the YannickKoenig/DIY-Laboratory-Power-Supply repository on GitHub; these links point at the commit this page was built from.

DC-DC-Buck Down: common questions

How big is the DC-DC-Buck Down PCB?

The DC-DC-Buck Down measures 89 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the DC-DC-Buck Down?

10 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the DC-DC-Buck Down design files?

From the YannickKoenig/DIY-Laboratory-Power-Supply repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the DC-DC-Buck Down design in my own project?

Yes, under the terms of its MIT license, which YannickKoenig chose for the repository.

More boards in DIY-Laboratory-Power-Supply

Similar boards