Hull20

0xdxn·hull20·pcb/boarding-pass/boarding-pass.kicad_pcb

Hull20 PCB layout, top view — open source board by 0xdxn

About the Hull20 PCB

Hull20 is an open source PCB design by 0xdxn, published on GitHub under the MIT license. It is a 2-layer board measuring 89 × 51 mm, with 19 components from 9 distinct parts.

By type, the board carries 10 resistors, 6 diodes, 2 transistors and 1 connector.

It belongs with the power & battery designs in this gallery.

From the project

HULL/20: an open-source LED flying saucer. Firmware, 2020 frame, cut files, a 3D build viewer and a boarding-pass PCB.

A souvenir card that is also a working circuit: 89 x 51 mm, 2 layers, 1.0 mm FR-4, black mask, ENIG gold, white silkscreen. Touch both halves of the gold disc and the beam lights. No battery, no radio, no firmware.

- USB-C, power only. CC1/CC2 pulled down with 5.1 kΩ, so any USB-C charger supplies 5 V. - The touch switch is the split gold disc on the front: left half = 5 V, right half = the amplifier's input through 100 kΩ. - Q1 + Q2 (MMBT3904) as a Darlington pair, gain about 10,000: the few microamps through a finger, a chain of hands or a pencil line switch about 30 mA into three beam…

Hull20, from the project README
From the project README

Hull20 bill of materials (BOM)

19 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
MMBT3904
Q1, Q2
1
C165948
USB-C
J1
6
LTST-C230KSKT
D1, D2, D3, D4, D5, D6
2
5.1K
5.1k
R1, R2
1
100K
100k
R3
1
10M
R4
1
4.7M
R5
4
220
R6, R7, R8, R10
1
4.7K
4.7k
R9

Hull20 design files

The KiCad project lives in the 0xdxn/hull20 repository on GitHub; these links point at the commit this page was built from.

Hull20: common questions

How big is the Hull20 PCB?

The Hull20 measures 89 × 51 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Hull20?

19 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Hull20 design files?

From the 0xdxn/hull20 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Hull20 design in my own project?

Yes, under the terms of its MIT license, which 0xdxn chose for the repository.

Similar boards