HardLabs

Driver

adamgreig·iggie·driver2/driver.kicad_pcb

Driver PCB layout, top view — open source FPGA board by adamgreig

About the Driver PCB

Driver is an open source FPGA PCB design by adamgreig, published on GitHub. It is a 2-layer board measuring 70 × 100 mm, with 4 components from 3 distinct parts.

Its main chip is the LFE5U-25F-xBG256, from the FPGA family. By type, the board carries 3 connectors and 1 IC.

Main components on the Driver

LFE5U-25F-xBG256

Driver bill of materials (BOM)

4 components, 3 distinct parts.

QtyPartRefs
1
LFE5U-25F-xBG256
IC201
1
CONN_02x32
J301
2
CONN_02x20
J401, J402

Driver design files

The KiCad project lives in the adamgreig/iggie repository on GitHub; these links point at the commit this page was built from.

Driver: common questions

What microcontroller does the Driver use?

The Driver is built around the LFE5U-25F-xBG256, from the FPGA family.

How big is the Driver PCB?

The Driver measures 70 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Driver?

4 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the Driver design files?

From the adamgreig/iggie repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Driver design in my own project?

The repository has no license, so all rights stay with adamgreig. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Driver without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug FPGA firmware against it before you order a PCB.

More boards in iggie

Similar boards