Vibration-Detector

adityarawat1223·Vibration-Detector·Hardware/Kicad/VibrationDT.kicad_pcb

Vibration-Detector PCB layout, top view — open source STM32 board by adityarawat1223

About the Vibration-Detector PCB

Vibration-Detector is an open source STM32 PCB design by adityarawat1223, published on GitHub. It is a 2-layer board measuring 60 × 56 mm, with 31 components from 13 distinct parts.

Its main chip is the STM32F100C8TX, from the STM32 family. Other key parts include the MPU-6050 and AP2112K-3.3. By type, the board carries 14 capacitors, 9 resistors, 3 ICs, 3 connectors and 2 switches.

It belongs with the displays & leds designs in this gallery.

From the project

Vibration Detector (MPU 6050 + Oled Output)

Main components on the Vibration-Detector

Vibration-Detector bill of materials (BOM)

31 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F100C8TX
STM32F100C8Tx
U1
1
MPU-6050
U2
1
AP2112K-3.3
U4
1
CONN_01X05_PIN
Conn_01x05_Pin
J1
1
USB_C_RECEPTACLE_POWERONLY_6P
USB_C_Receptacle_PowerOnly_6P
J2
1
CONN_01X04_PIN
Conn_01x04_Pin
J3
2
SW_Push
SW1, SW2
3
1UF
1uF
C1, C10, C14
9
100NF
100nF
C2, C3, C4, C5, C6, C7, C8, C9 +1
1
0.1UF
0.1uF
C12
1
2.2NF
2.2nF
C13
2
10K
R1, R2
7
5.1K
R3, R4, R5, R6, R7, R8, R9

Vibration-Detector design files

The KiCad project lives in the adityarawat1223/Vibration-Detector repository on GitHub; these links point at the commit this page was built from.

Vibration-Detector: common questions

What microcontroller does the Vibration-Detector use?

The Vibration-Detector is built around the STM32F100C8TX, from the STM32 family.

How big is the Vibration-Detector PCB?

The Vibration-Detector measures 60 × 56 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Vibration-Detector?

31 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Vibration-Detector design files?

From the adityarawat1223/Vibration-Detector repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Vibration-Detector design in my own project?

The repository has no license, so all rights stay with adityarawat1223. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Vibration-Detector without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards