Led flashlight

About the Led flashlight PCB

Led flashlight is an open source PCB design by akshayparseja, published on GitHub. It is a 2-layer board, with 3 components from 3 distinct parts.

By type, the board carries 1 diode and 1 resistor.

It belongs with the audio designs in this gallery.

From the project

OpenPCB: Fully Open-Source Automated PCB Generation using Code-Driven Layout Synthesis.

1. Install KiCad (recommended 7 or 8). On macOS you can use the official installer from https://kicad.org or Homebrew:

2. Install SKiDL (optional for later phases):

3. Run the Phase 1 script (it will try to use pcbnew if available; otherwise it writes a fallback hello.kicadpcb` using local footprints):

4. Open hello.kicadpcb` in KiCad (File -> Open) to confirm the two footprints are present.

3 components, 3 distinct parts.

Qty	Part	Refs
1	Battery	B1
1	LED	D1
1	330	R1

The KiCad project lives in the akshayparseja/OpenPCB repository on GitHub; these links point at the commit this page was built from.

The Led flashlight has 2 copper layers and is 1.6 mm thick.

3 components, from 3 distinct parts. The full bill of materials is listed on this page.

From the akshayparseja/OpenPCB repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

The repository has no license, so all rights stay with akshayparseja. Use it as a reference, and ask the author before reusing the design.