HardLabs

V1

ARTS-Laboratory·IoT-Water-Level-Sensor·system_development/Cellular/v0.1/EDA/datalogger_board_v1/v1.kicad_pcb

V1 PCB layout, top view — open source AVR/Arduino board by ARTS-Laboratory

About the V1 PCB

V1 is an open source AVR/Arduino PCB design by ARTS-Laboratory, published on GitHub under the CC-BY-SA-4.0 license. It is a 2-layer board measuring 34.9 × 53.3 mm, with 15 components from 7 distinct parts.

Its main chip is the Arduino_Mega2560_Shield, from the AVR/Arduino family. By type, the board carries 8 resistors, 2 capacitors and 1 battery holder.

It belongs with the sensors and iot & wireless designs in this gallery.

From the project

A low-cost, IOT water level sensor package alternative to traditional gauging equipment.

V1, from the project README
From the project README

V1 bill of materials (BOM)

15 components, 7 distinct parts.

QtyPartRefs
1
TC2014-3.3VxCTTR
ADP121
1
Battery_Cell
BT1
1
DS3231M
DS3231
1
HCSR04
JSN-SR04
1
Arduino_Mega2560_Shield
XA1
2
C
C1, C2
8
R
R1, R2, R3, R4, R5, R6, R7, R8

V1 design files

The KiCad project lives in the ARTS-Laboratory/IoT-Water-Level-Sensor repository on GitHub; these links point at the commit this page was built from.

V1: common questions

What microcontroller does the V1 use?

The V1 is built around the Arduino_Mega2560_Shield, from the AVR/Arduino family.

How big is the V1 PCB?

The V1 measures 34.9 × 53.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the V1?

15 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the V1 design files?

From the ARTS-Laboratory/IoT-Water-Level-Sensor repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the V1 design in my own project?

Yes, under the terms of its CC-BY-SA-4.0 license, which ARTS-Laboratory chose for the repository.

Can I test firmware for the V1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in IoT-Water-Level-Sensor

Similar boards