HardLabs

TITAN-BLINKER

avadsariya0-coder·TITAN-BLINKER·PCB/titan c.kicad_pcb

TITAN-BLINKER PCB layout, top view — open source RP2040/RP2350 board by avadsariya0-coder

About the TITAN-BLINKER PCB

TITAN-BLINKER is an open source RP2040/RP2350 PCB design by avadsariya0-coder, published on GitHub under the MIT license. It is a 2-layer board measuring 51.5 × 63.6 mm, with 10 components from 4 distinct parts.

Its main chip is the XIAO-RP2040-DIP, from the RP2040/RP2350 family. By type, the board carries 3 switches, 3 diodes, 3 resistors and 1 IC.

From the project

___________________________________________________________________________________________________________________________________________________________________________

___________________________________________________________________________________________________________________________________________________________________________

Titan Blinker is LED blinker built using XIAO RP2040 microcontroller and mechanical switches. The Titan blinker contains electronics,pcb designing and firmware designing.

Unlike the other LED blinker Titan blinker contains XIAO RP2040 and switches. Most of the blinker uses battery instead of microcontroller but titan blinker uses XIAO RP2040 and switches programmed using Arduino. The switches helps in turning on the…

TITAN-BLINKER, from the project README
From the project README

Main components on the TITAN-BLINKER

XIAO-RP2040-DIP

TITAN-BLINKER bill of materials (BOM)

10 components, 4 distinct parts.

QtyPartRefs
1
XIAO-RP2040-DIP
U1
3
SW_Push
SW1, SW2, SW3
3
L08R5000Q1
D1, D2, D3
3
R
R1, R2, R3

TITAN-BLINKER design files

The KiCad project lives in the avadsariya0-coder/TITAN-BLINKER repository on GitHub; these links point at the commit this page was built from.

TITAN-BLINKER: common questions

What microcontroller does the TITAN-BLINKER use?

The TITAN-BLINKER is built around the XIAO-RP2040-DIP, from the RP2040/RP2350 family.

How big is the TITAN-BLINKER PCB?

The TITAN-BLINKER measures 51.5 × 63.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the TITAN-BLINKER?

10 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the TITAN-BLINKER design files?

From the avadsariya0-coder/TITAN-BLINKER repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the TITAN-BLINKER design in my own project?

Yes, under the terms of its MIT license, which avadsariya0-coder chose for the repository.

Can I test firmware for the TITAN-BLINKER without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards