HardLabs

Flight-Controller-

ayushmanyadav2006·Flight-Controller-

Flight-Controller- PCB layout, top view — open source AVR/Arduino board by ayushmanyadav2006

About the Flight-Controller- PCB

Flight-Controller- is an open source AVR/Arduino PCB design by ayushmanyadav2006, published on GitHub. It is a 2-layer board measuring 89 × 103.5 mm, with 24 components from 13 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. Other key parts include the 74HC595. By type, the board carries 10 resistors, 4 diodes, 3 connectors, 3 switches, 2 ICs and 1 module.

It belongs with the robotics & motion designs in this gallery.

From the project

Created a electronic control hardware to control the roll, pitch, yaw of a airplane Also the speed of the airplane, landing gears etc

Created a electronic control hardware to control the roll, pitch, yaw of a airplane Also the speed of the airplane, landing gears etc

The electronics consists of Arduino Uno (Microcontroller board) Joystick (Controlling the roll and pitch) Potentiometer (Controlling the speed of the airplane) Buttons (Controlling the yaw of the airplane) Joystick button (Controlling the landing gear)

Main components on the Flight-Controller-

74HC595Arduino_UNO_R3

Flight-Controller- bill of materials (BOM)

24 components, 13 distinct parts.

QtyPartRefs
2
74HC595
U1, U2
1
Arduino_UNO_R3
A1
1
Conn_01x05_Pin
J1
2
Conn_01x03_Pin
J2, J3
1
HDSP-4830_2
BAR1
1
Rudder right
SW1
1
Rudder left
SW2
1
Breaks
SW3
1
right led
D1
1
forward led
D2
1
backward led
D3
1
left led
D4
10
330
R1, R2, R3, R4, R5, R6, R7, R8 +2

Flight-Controller- design files

The KiCad project lives in the ayushmanyadav2006/Flight-Controller- repository on GitHub; these links point at the commit this page was built from.

Flight-Controller-: common questions

What microcontroller does the Flight-Controller- use?

The Flight-Controller- is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How big is the Flight-Controller- PCB?

The Flight-Controller- measures 89 × 103.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Flight-Controller-?

24 components, from 13 distinct parts. The full bill of materials is listed on this page.

Where can I download the Flight-Controller- design files?

From the ayushmanyadav2006/Flight-Controller- repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Flight-Controller- design in my own project?

The repository has no license, so all rights stay with ayushmanyadav2006. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Flight-Controller- without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards