HardLabs

BATS

brico-labs·BATS·kicad/bats.kicad_pcb

BATS PCB layout, top view — open source AVR/Arduino board by brico-labs

About the BATS PCB

BATS is an open source AVR/Arduino PCB design by brico-labs, published on GitHub. It is a 2-layer board measuring 68.9 × 53.6 mm, with 28 components from 16 distinct parts.

Its main chip is the ARDUINO_SHIELD, from the AVR/Arduino family. Other key parts include the BUZZER. By type, the board carries 13 resistors, 6 LEDs, 4 switches, 1 IC and 1 connector.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

BricoLabs Arduino Training Shield

NOTA IMPORTANTE Lee a sección META para clonar este proxecto.

Qué imos facer? Qué se describe en este documento? ==================================================

Imos deseñar un shield para Arduino usando KiCad

Daremos unha visión xeral da funcionalidade da suite KiCad pero non vamos a redactar un tutorial detallado nin de deseño de circuitos nin do mesmo KiCad. Daremos as pistas xustiñas para empezar a traballar con KiCad, se queredes un tutorial detallado, en youtube tedes un super recomendable, elaborado por TutoElectro

Main components on the BATS

BUZZER

BATS bill of materials (BOM)

28 components, 16 distinct parts.

QtyPartRefs
1
BUZZER
U1
1
SERVO
P1
1
ARDUINO_SHIELD
SHIELD1
1
RESET
SW1
1
SHOT
SW2
1
LEFT
SW4
1
RIGHT
SW6
2
POT
VR1, VR2
1
Red LED
LED1
1
Yellow LED
LED2
1
Green LED
LED3
1
LED_RGB_COM_K
LED4
2
LED
LED5, LED6
1
RES_PHOTO_LDR
R1
4
10K
R2, R9, R11, R13
8
220
R3, R4, R5, R6, R7, R8, R10, R12

BATS design files

The KiCad project lives in the brico-labs/BATS repository on GitHub; these links point at the commit this page was built from.

BATS: common questions

What microcontroller does the BATS use?

The BATS is built around the ARDUINO_SHIELD, from the AVR/Arduino family.

How big is the BATS PCB?

The BATS measures 68.9 × 53.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the BATS?

28 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the BATS design files?

From the brico-labs/BATS repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the BATS design in my own project?

The repository has no license, so all rights stay with brico-labs. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the BATS without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards