Digitizer-1

chew-in·digitizer-1·hw/Digitizer.kicad_pcb

Digitizer-1 PCB layout, top view — open source FPGA board by chew-in

About the Digitizer-1 PCB

Digitizer-1 is an open source FPGA PCB design by chew-in, published on GitHub. It is a 4-layer board measuring 50 × 100 mm, with 77 components from 14 distinct parts.

Its main chip is the MachXO2, from the FPGA family. Other key parts include the AD8014, AD9283, NCP1117 and MIC5270. By type, the board carries 43 capacitors, 17 resistors, 9 ICs, 5 connectors and 2 diodes.

It belongs with the usb & debug tools designs in this gallery.

Main components on the Digitizer-1

AD8014AD9283MachXO2NCP1117MIC5270

Digitizer-1 bill of materials (BOM)

77 components, 14 distinct parts.

QtyPartRefs
2
AD8014
U1, U3
2
AD9283
U2, U4
1
MachXO2
U5
3
NCP1117
U6, U7, U8
1
MIC5270
U9
3
SMA
J1, J2, J3
1
Conn_x4
J7
1
Conn_x64
J10
1
510CBA25M0000BAGR
G1
2
LED
D1, D2
2
1u
C1, C10
41
C
C2, C3, C4, C5, C6, C7, C8, C9 +33
5
50
R1, R2, R8, R9, R10
12
R
R3, R4, R5, R6, R7, R11, R12, R13 +4

Digitizer-1 design files

The KiCad project lives in the chew-in/digitizer-1 repository on GitHub; these links point at the commit this page was built from.

Digitizer-1: common questions

What microcontroller does the Digitizer-1 use?

The Digitizer-1 is built around the MachXO2, from the FPGA family.

How big is the Digitizer-1 PCB?

The Digitizer-1 measures 50 × 100 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Digitizer-1?

77 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Digitizer-1 design files?

From the chew-in/digitizer-1 repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Digitizer-1 design in my own project?

The repository has no license, so all rights stay with chew-in. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Digitizer-1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug FPGA firmware against it before you order a PCB.

Similar boards