Chili audio module hardware
chili-chip·chili-audio-module-hardware
About the Chili audio module hardware
Chili audio module hardware is an open source PCB design by chili-chip, published on GitHub. It is a 2-layer board measuring 11.5 × 17.5 mm, with 5 components from 5 distinct parts.
Other key parts include the MAX98357A. By type, the board carries 2 capacitors, 1 IC, 1 connector and 1 resistor.
It belongs with the audio designs in this gallery.
From the project
Kicad project for chilichip audio module running a MAX98357A I2S Audio IC
KiCad 10 project for the chilichip audio module: a tiny I²S mono speaker amplifier based on the MAX98357A, made to be soldered flat onto a host board through castellated edge pads. It is the audio board for chilichip's VGC Zero game console, and works with any 3.3 V microcontroller that can output I²S (RP2040/RP2350, ESP32, …).
The speaker output is bridge-tied (OUTP/OUTN). Connect the speaker across the two connector pins, and don't tie either one to ground.

Main components on the Chili audio module hardware
Chili audio module hardware bill of materials (BOM)
5 components, 5 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | MAX98357A | TQFN-16-1EP_3x3mm_P0.5mm_EP1.23x1.23mm_ThermalVias | U1 |
| 1 | MX1.25_2Pin | Molex_PicoBlade_53261-0271_1x02-1MP_P1.25mm_Horizontal | J3 |
| 1 | 10uF | C_0402_1005Metric | C1 |
| 1 | 100nF | C_0402_1005Metric | C2 |
| 1 | 510k | R_0603_1608Metric | R1 |
Chili audio module hardware design files
The KiCad project lives in the chili-chip/chili-audio-module-hardware repository on GitHub; these links point at the commit this page was built from.
Chili audio module hardware: common questions
How big is the Chili audio module hardware?
The Chili audio module hardware measures 11.5 × 17.5 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Chili audio module hardware?
5 components, from 5 distinct parts. The full bill of materials is listed on this page.
Where can I download the Chili audio module hardware design files?
From the chili-chip/chili-audio-module-hardware repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Chili audio module hardware design in my own project?
The repository has no license, so all rights stay with chili-chip. Use it as a reference, and ask the author before reusing the design.
Similar boards
KLOR
GEIGEIGEIST
160.2 × 118.3 mm79 parts2LGPL-3.01.2kButtonsLEDs
shanteacontrols
390 × 37 mm82 parts2LApache-2.0956USB
shanteacontrols
52 × 12.6 mm6 parts2LApache-2.0956Pots
shanteacontrols
390 × 93 mm75 parts2LApache-2.0956PicoGUS Hand386
polpo
29.2 × 75.2 mm43 parts4LGPL-2.0800Snark barker
schlae
231.1 × 106.7 mm193 parts2LNo license687