FritzenLab egg timer

clovisf·FritzenLab-egg-timer

FritzenLab egg timer PCB layout, top view — open source PIC board by clovisf

About the FritzenLab egg timer PCB

FritzenLab egg timer is an open source PIC PCB design by clovisf, published on GitHub. It is a 2-layer board measuring 34.5 × 34.5 mm, with 14 components from 11 distinct parts.

Its main chip is the PIC12F675-xSN, from the PIC family. By type, the board carries 5 resistors, 2 connectors, 2 switches, 1 IC, 1 transistor and 1 buzzer.

It belongs with the displays & leds designs in this gallery.

From the project

A PIC-based no-display egg timer (15 to 60 minutes)

Main components on the FritzenLab egg timer

PIC12F675-xSN

FritzenLab egg timer bill of materials (BOM)

14 components, 11 distinct parts.

QtyPartRefs
1
PIC12F675-xSN
U1
1
BC848
Q1
2
Conn_01x05_Pin
J1, J2
1
Buzzer
BZ1
2
SW_Push_Dual
SW1, SW2
1
LED
D1
1
100n
C1
1
1k
R1
2
47k
R2, R3
1
68k
R4
1
470
R5

FritzenLab egg timer design files

The KiCad project lives in the clovisf/FritzenLab-egg-timer repository on GitHub; these links point at the commit this page was built from.

FritzenLab egg timer: common questions

What microcontroller does the FritzenLab egg timer use?

The FritzenLab egg timer is built around the PIC12F675-xSN, from the PIC family.

How big is the FritzenLab egg timer PCB?

The FritzenLab egg timer measures 34.5 × 34.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the FritzenLab egg timer?

14 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the FritzenLab egg timer design files?

From the clovisf/FritzenLab-egg-timer repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the FritzenLab egg timer design in my own project?

The repository has no license, so all rights stay with clovisf. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the FritzenLab egg timer without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

Similar boards