HardLabs

RGB Par

cookiemonsternz·StageKit·RGB Par/RGB Par.kicad_pcb

RGB Par PCB layout, top view — open source AVR/Arduino board by cookiemonsternz

About the RGB Par PCB

RGB Par is an open source AVR/Arduino PCB design by cookiemonsternz, published on GitHub. It is a 2-layer board measuring 28 × 28 mm, with 9 components from 7 distinct parts.

Its main chip is the ATtiny85-20P, from the AVR/Arduino family. By type, the board carries 4 resistors, 2 connectors, 1 IC, 1 switch and 1 diode.

From the project

Stagekit is a 3D-printable, completely hand-solderable diy lighting previs kit.

Stagekit is a 3D-printable, completely hand-solderable diy lighting previs kit.

It consists of various fixtures, truss elements, and set dressing pieces, all modelled at a fairly accurate 1:10 scale. The truss pieces are modelled after standard Eurotruss, and the lights after various fixtures, but due to design requirements, sizing and design liberties have had to be taken.

RGB Par, from the project README
From the project README

Main components on the RGB Par

ATtiny85-20P

RGB Par bill of materials (BOM)

9 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ATtiny85-20P
U1
2
530470410
J1, J3
1
SW_Push
SW1
1
~
D1
1
150
R1
2
100
R2, R3
1
10k
R4

RGB Par design files

The KiCad project lives in the cookiemonsternz/StageKit repository on GitHub; these links point at the commit this page was built from.

RGB Par: common questions

What microcontroller does the RGB Par use?

The RGB Par is built around the ATtiny85-20P, from the AVR/Arduino family.

How big is the RGB Par PCB?

The RGB Par measures 28 × 28 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the RGB Par?

9 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the RGB Par design files?

From the cookiemonsternz/StageKit repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the RGB Par design in my own project?

The repository has no license, so all rights stay with cookiemonsternz. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the RGB Par without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in StageKit

Similar boards