HardLabs

Tutorial02

D76X·KiCad·Projects/Tutorial02/Tutorial02.kicad_pcb

Tutorial02 PCB layout, top view — open source AVR/Arduino board by D76X

About the Tutorial02 PCB

Tutorial02 is an open source AVR/Arduino PCB design by D76X, published on GitHub. It is a 2-layer board measuring 39.3 × 55 mm, with 17 components from 14 distinct parts.

Its main chip is the ATMEGA328P-PU, from the AVR/Arduino family. By type, the board carries 6 connectors, 5 capacitors, 2 resistors, 1 IC, 1 crystal and 1 switch.

From the project

KiCad Projects

KiCad 9: Design & assemble an ESP32 IoT 4-layer PCB loaded with goodies A Complete Guide Tech Explorations

Peter Dalmaris futureshocked : KLP-5e-ESP32-sensor-board

1. Copper zones for GND 2. Copper zones for power 3. Differential pairs 4. Clock and high-speed signals 5. Power traces 6. All other signals 7. Optimization

SS-52400-002 Stewart Connector USB Type-C Connector | USB 3.1 | 1 Port | Right Angle Receptacle | Shielded | 0.039 in (1.00mm) PCB Thickness

Main components on the Tutorial02

ATMEGA328P-PU

Tutorial02 bill of materials (BOM)

17 components, 14 distinct parts.

QtyPartRefs
1
ATMEGA328P-PU
Microchip Technology
U1
1
Crystal
Y1
1
FTDI Programmer
J1
1
Arduino PIN0 - PIN7
J2
1
Arduino A0 - A5
J3
1
Power & Ground Terminal
J4
1
Versorgungsspannung
J5
1
Arduino PIN8 - PIN13
J6
1
SW_Push
SW1
1
LED
D1
3
100nF
C1, C2, C3
2
22pF
C4, C5
1
10K
R1
1
R
R3

Tutorial02 design files

The KiCad project lives in the D76X/KiCad repository on GitHub; these links point at the commit this page was built from.

Tutorial02: common questions

What microcontroller does the Tutorial02 use?

The Tutorial02 is built around the ATMEGA328P-PU, from the AVR/Arduino family.

How big is the Tutorial02 PCB?

The Tutorial02 measures 39.3 × 55 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Tutorial02?

17 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Tutorial02 design files?

From the D76X/KiCad repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Tutorial02 design in my own project?

The repository has no license, so all rights stay with D76X. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Tutorial02 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in KiCad

Similar boards