HardLabs

Fs pcb

DanHughesWorkSpace·fs_pcb

This repository ships a schematic but no board layout.

About the Fs pcb

Fs pcb is an open source Nordic nRF PCB design by DanHughesWorkSpace, published on GitHub. It is a board, with 1 components from 1 distinct parts.

Its main chip is the NRF52832-QFAA, from the Nordic nRF family.

It belongs with the wearables, rf & radio and iot & wireless designs in this gallery.

From the project

FitSwitch is a compact wearable health tracking module designed to attach to the back of an analog watch. It tracks heart rate via PPG optical sensor and step count via accelerometer, communicating over Bluetooth Low Energy to a paired device (mobile phone).

FitSwitch is a compact wearable health tracking module designed to attach to the back of an analog watch. It tracks heart rate via PPG optical sensor and step count via accelerometer, communicating over Bluetooth Low Energy to a paired device (mobile phone).

This repository contains an EVT (Engineering Validation Test) design specification, put together by a software developer with no electronics background using AI-assisted design. It represents a proposed direction - not a final specification. Component choices, architecture decisions, and layout approaches are all open to challenge and…

Main components on the Fs pcb

NRF52832-QFAA

Fs pcb bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
NRF52832-QFAA
nRF52832-QFAA
Nordic Semiconductor
U1

Fs pcb design files

The KiCad project lives in the DanHughesWorkSpace/fs_pcb repository on GitHub; these links point at the commit this page was built from.

Fs pcb: common questions

What microcontroller does the Fs pcb use?

The Fs pcb is built around the NRF52832-QFAA, from the Nordic nRF family.

How many components are on the Fs pcb?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Fs pcb design files?

From the DanHughesWorkSpace/fs_pcb repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Fs pcb design in my own project?

The repository has no license, so all rights stay with DanHughesWorkSpace. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Fs pcb without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Nordic nRF firmware against it before you order a PCB.

Similar boards