PI5-HAT-relocator
DBG-Robots·PI5-HAT-relocator
About the PI5-HAT-relocator
PI5-HAT-relocator is an open source PCB design by DBG-Robots, published on GitHub under the GPL-2.0 license. It is a 2-layer board measuring 50.3 × 56 mm, with 16 components from 2 distinct parts.
It belongs with the robotics & motion and dev boards & breakouts designs in this gallery.
From the project
A simple, shallow KiCad board that lets the Kinematics Kit HAT fit into a narrow robot frame: female connectors on top, male connectors on bottom.
A simple, shallow KiCad board that lets the Kinematics Kit HAT fit into a narrow robot frame: female connectors on top, male connectors on bottom.
Our robot uses the Kinematics Kit by Eduard as its motor and drive electronics. In its canonical layout, the motor connectors stick out on the sides of the HAT. That is fine for most builds, but it costs width, and width is exactly what we do not have.

PI5-HAT-relocator bill of materials (BOM)
16 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 8 | CONN_01X02_PIN Conn_01x02_Pin | PinHeader_1x02_P2.54mm_Vertical | J1, J3, J5, J7, J9, J11, J13, J15 |
| 8 | CONN_01X02_SOCKET Conn_01x02_Socket | PinSocket_1x02_P2.54mm_Vertical | J2, J4, J6, J8, J10, J12, J14, J16 |
PI5-HAT-relocator design files
The KiCad project lives in the DBG-Robots/PI5-HAT-relocator repository on GitHub; these links point at the commit this page was built from.
PI5-HAT-relocator: common questions
How big is the PI5-HAT-relocator?
The PI5-HAT-relocator measures 50.3 × 56 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the PI5-HAT-relocator?
16 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the PI5-HAT-relocator design files?
From the DBG-Robots/PI5-HAT-relocator repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the PI5-HAT-relocator design in my own project?
Yes, under the terms of its GPL-2.0 license, which DBG-Robots chose for the repository.
Similar boards
Stack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7k134pin 7-967288-1
rusefi
139.7 × 73.7 mm38 parts2LGPL-3.01.2kEecv breakout
rusefi
140.8 × 53.7 mm9 parts4LGPL-3.01.2k88 Pin Vag Breakout
rusefi
142 × 58 mm91 parts2LGPL-3.01.2kBreakout 60pin EEC-IV
rusefi
139.7 × 62.2 mm15 parts2LGPL-3.01.2kBreakout 112pin Connector
rusefi
174 × 58 mm39 parts2LGPL-3.01.2k