LED ENCODER SWITCH ADAPTER BOARD

dmitry-lif·kb-e2b6·hardware/encoder_db/encoder_db.kicad_pcb

LED ENCODER SWITCH ADAPTER BOARD layout, top view — open source board by dmitry-lif

About the LED ENCODER SWITCH ADAPTER BOARD

LED ENCODER SWITCH ADAPTER BOARD is an open source PCB design by dmitry-lif, published on GitHub under the Apache-2.0 license. It is a 2-layer board measuring 24.3 × 15.7 mm, with 4 components from 3 distinct parts.

By type, the board carries 3 resistors and 1 connector.

It belongs with the keyboards designs in this gallery.

From the project

Small USB controller for backlit rotary encoders and push buttons, seen by the host as a keyboard

KB-E2B6 is a small (45 × 35 mm) open-source controller for physical controls. You connect up to two rotary encoders with push switches and six push buttons, all of them backlit if you like, and run one USB cable to the host. The host sees an ordinary USB keyboard. You choose once, in a web page (the configurator), what each control sends, and the controller remembers this setup.

LED ENCODER SWITCH ADAPTER BOARD, from the project README
From the project README

LED ENCODER SWITCH ADAPTER BOARD bill of materials (BOM)

4 components, 3 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
C51940119
Conn_01x06
J1
2
C23025
300R
R1, R3
1
C22808
150R
R2

LED ENCODER SWITCH ADAPTER BOARD design files

The KiCad project lives in the dmitry-lif/kb-e2b6 repository on GitHub; these links point at the commit this page was built from.

LED ENCODER SWITCH ADAPTER BOARD: common questions

How big is the LED ENCODER SWITCH ADAPTER BOARD?

The LED ENCODER SWITCH ADAPTER BOARD measures 24.3 × 15.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the LED ENCODER SWITCH ADAPTER BOARD?

4 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the LED ENCODER SWITCH ADAPTER BOARD design files?

From the dmitry-lif/kb-e2b6 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the LED ENCODER SWITCH ADAPTER BOARD design in my own project?

Yes, under the terms of its Apache-2.0 license, which dmitry-lif chose for the repository.

More boards in kb-e2b6

Similar boards