HardLabs

Radiodzem

dzemchmielewski·raspberryPi-radio·kicad/radiodzem/radiodzem.kicad_pcb

Radiodzem PCB layout, top view — open source Raspberry Pi board by dzemchmielewski

About the Radiodzem PCB

Radiodzem is an open source Raspberry Pi PCB design by dzemchmielewski, published on GitHub. It is a 2-layer board measuring 146 × 78 mm, with 24 components from 12 distinct parts.

Its main chip is the PinHeader_RaspberryPi_reversed, from the Raspberry Pi family. By type, the board carries 7 resistors, 5 switches, 3 LEDs, 2 connectors and 1 diode.

It belongs with the displays & leds and rf & radio designs in this gallery.

From the project

Radio for playing internet streams, with knobs, buttons, LEDs and OLED display

Radio for playing internet streams, with knobs, buttons, LEDs and OLED display

./software - python code ./kicad - kicad files for schematic, PCB and plexi cut out

Radiodzem bill of materials (BOM)

24 components, 12 distinct parts.

QtyPartRefs
1
Conn_01x08
J1
1
Conn_01x04
power-out1
1
Conn_01x02
5v-input1
1
Conn_01x02
5v-output1
2
~
RE1, RE2
1
Conn_02x20_reversed_raspberry
RaspberryPi1
1
Conn_01x07_4(+1)-wire_SPI
SPI1
5
SW_MEC_5E
SW1, SW2, SW3, SW4, SW5
3
LED
LED1, LED2, LED3
1
~
D1
3
R
R1, R2, R3
4
1,2kOhm
R4, R5, R6, R7

Radiodzem design files

The KiCad project lives in the dzemchmielewski/raspberryPi-radio repository on GitHub; these links point at the commit this page was built from.

Radiodzem: common questions

What microcontroller does the Radiodzem use?

The Radiodzem is built around the PinHeader_RaspberryPi_reversed, from the Raspberry Pi family.

How big is the Radiodzem PCB?

The Radiodzem measures 146 × 78 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Radiodzem?

24 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the Radiodzem design files?

From the dzemchmielewski/raspberryPi-radio repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Radiodzem design in my own project?

The repository has no license, so all rights stay with dzemchmielewski. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Radiodzem without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

Similar boards