Copycat

FE3C61AD329B·RGT6

Copycat PCB layout, top view — open source STM32 board by FE3C61AD329B

About the Copycat PCB

Copycat is an open source STM32 PCB design by FE3C61AD329B, published on GitHub. It is a 2-layer board measuring 35.6 × 15.2 mm, with 37 components from 27 distinct parts.

Its main chip is the STM32F411CEUx, from the STM32 family. Other key parts include the SPX3819, MCP73811T-420I/OT and MicroSD_SPI_CD. By type, the board carries 11 resistors, 9 capacitors, 4 ICs, 3 diodes, 2 connectors and 1 crystal.

From the project

A minimal system runs MicroPython using STM32F405RGT6

A minimal system runs MicroPython using STM32F405RGT6

Designed in KiCAD, free to use in any application.

PCB preview in KiCAD Actual PCB And the size of its stencil

Copycat, from the project README
From the project README

Main components on the Copycat

Copycat bill of materials (BOM)

37 components, 27 distinct parts.

QtyPartRefs
1
SPX3819
U1
1
MCP73811T-420I/OT
U2
1
STM32F411CEUx
U3
1
MicroSD_SPI_CD
U4
1
32.768Hz
Y1
1
CONN_01X02
P2
1
USB_OTG
P4
1
0.1uF
CAREF1
3
10uF
CB1, CVI1, CVO1
1
4.7uF
CG1
1
1uF
CVO2
1
RST
SW1
1
ORANGE
D1
1
RED
D3
1
BLUE
D4
2
2.2pF
C1, C2
1
2.2uF
C3
2
18pF
C4, C5
1
4.7uF
C6
3
0.1uF
C24, C36, C48
Show 7 more
QtyPartRefs
3
100k
R1, R4, R5
1
1k
R2
1
4k7
R3
2
10k
R6, R9
1
560
R7
1
220
R8
2
22
R10, R11

Copycat design files

The KiCad project lives in the FE3C61AD329B/RGT6 repository on GitHub; these links point at the commit this page was built from.

Copycat: common questions

What microcontroller does the Copycat use?

The Copycat is built around the STM32F411CEUx, from the STM32 family.

How big is the Copycat PCB?

The Copycat measures 35.6 × 15.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Copycat?

37 components, from 27 distinct parts. The full bill of materials is listed on this page.

Where can I download the Copycat design files?

From the FE3C61AD329B/RGT6 repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Copycat design in my own project?

The repository has no license, so all rights stay with FE3C61AD329B. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Copycat without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in RGT6

Similar boards