Pps splitter

folkertvanheusden·pps-splitter

Pps splitter PCB layout, top view — open source board by folkertvanheusden

About the Pps splitter PCB

Pps splitter is an open source PCB design by folkertvanheusden, published on GitHub. It is a 2-layer board measuring 47.5 × 65.5 mm, with 12 components from 5 distinct parts.

Other key parts include the 74HC04. By type, the board carries 6 connectors, 4 resistors, 1 IC and 1 capacitor.

It belongs with the rf & radio designs in this gallery.

From the project

splits 1 PPS signal into 4, with buffering

This piece of electronics is a splitter for PPS signals. From 1 to 4 and also including a nice header that allows you to measure the delay introduced by the buffer IC. I've obtained the schematic from https://klubnl.pl/wpr/en/artykuly/proste-zrodlo-sygnalu-1pps/ Did not test it yet.

Main components on the Pps splitter

Pps splitter bill of materials (BOM)

12 components, 5 distinct parts.

QtyPartRefs
1
74HC04
U1
5
Conn_Coaxial
J1, J2, J3, J4, J6
1
Conn_01x04_Pin
J5
1
C
C1
4
47 Ohm
R2, R3, R4, R5

Pps splitter design files

The KiCad project lives in the folkertvanheusden/pps-splitter repository on GitHub; these links point at the commit this page was built from.

Pps splitter: common questions

How big is the Pps splitter PCB?

The Pps splitter measures 47.5 × 65.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pps splitter?

12 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pps splitter design files?

From the folkertvanheusden/pps-splitter repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pps splitter design in my own project?

The repository has no license, so all rights stay with folkertvanheusden. Use it as a reference, and ask the author before reusing the design.

Similar boards