Tang tiny gpu

fpt·tang-tiny-gpu·harness/kicad/v2/rp-tang-harness-v2.kicad_pcb

Tang tiny gpu PCB layout, top view — open source RP2040/RP2350 board by fpt

About the Tang tiny gpu PCB

Tang tiny gpu is an open source RP2040/RP2350 PCB design by fpt, published on GitHub under the SHL-2.1 license. It is a 2-layer board measuring 56 × 76 mm, with 10 components from 5 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. Other key parts include the Sipeed_Tang_Nano_20K. By type, the board carries 7 resistors, 1 IC, 1 module and 1 capacitor.

From the project

A small retro-console-style GPU built on the FPGA of a Tang Nano 20K (Gowin GW2AR-18). The intended host CPU is an RP2350.

A small retro-console-style GPU built on the FPGA of a Tang Nano 20K (Gowin GW2AR-18). The intended host CPU is an RP2350.

The FPGA has two bitstreams. Both are stored in flash, and the host switches between them through the RECONFIG register (about 1.7 s).

Both output a 320 x 240 image as 640 x 480 @ 60Hz HDMI (DVI), and both talk to the host through the same SPI registers and command FIFO.

Tang tiny gpu, from the project README
From the project README

Main components on the Tang tiny gpu

Sipeed_Tang_Nano_20KRaspberryPi_Pico

Tang tiny gpu bill of materials (BOM)

10 components, 5 distinct parts.

QtyPartRefs
1
Sipeed_Tang_Nano_20K
U3
1
RaspberryPi_Pico
A1
1
0.1u
C4
5
33
R4, R5, R6, R7, R8
2
4.7k
R9, R10

Tang tiny gpu design files

The KiCad project lives in the fpt/tang-tiny-gpu repository on GitHub; these links point at the commit this page was built from.

Tang tiny gpu: common questions

What microcontroller does the Tang tiny gpu use?

The Tang tiny gpu is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the Tang tiny gpu PCB?

The Tang tiny gpu measures 56 × 76 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Tang tiny gpu?

10 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Tang tiny gpu design files?

From the fpt/tang-tiny-gpu repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Tang tiny gpu design in my own project?

It is published under SHL-2.1, which limits how it may be reused; read the license before building on it.

Can I test firmware for the Tang tiny gpu without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Earlier revisions in the repo: rp-tang-harness

Similar boards