HardLabs

EVOLVER Temperature Calibration Module

FYNCH-BIO·hardware·Accessories/temp-cal/temperature board.kicad_pcb

EVOLVER Temperature Calibration Module layout, top view — open source AVR/Arduino board by FYNCH-BIO
Simulate this board

About the EVOLVER Temperature Calibration Module

EVOLVER Temperature Calibration Module is an open source AVR/Arduino PCB design by FYNCH-BIO, published on GitHub. It is a 2-layer board measuring 92.7 × 82.6 mm, with 28 components from 12 distinct parts.

Its main chip is the arduinoChip, from the AVR/Arduino family. Other key parts include the 9_R_01x10. By type, the board carries 22 connectors, 4 capacitors and 2 ICs.

It belongs with the sensors designs in this gallery.

From the project

eVOLVER Hardware (PCB, 3D printed parts)

For more information on the platform, check out our Nature Biotech publication.

For information on building, troubleshooting, and running experiments on the platform, reach out to us on the eVOLVER forum and read the wiki.

Main components on the EVOLVER Temperature Calibration Module

9_R_01x10

EVOLVER Temperature Calibration Module bill of materials (BOM)

28 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
CONN_02X12
9_R_01x10
U1, U2
1
Barrel_Jack
J1
13
Conn_01x02
J2, J3, J5, J6, J9, J12, J13, J14 +5
1
CONN_02X03
Conn_01x02
J4
2
RJ14
Conn_01x02
J7, J8
1
Connector_Generic_Conn_02x25_Row_Letter_Last
J10
1
Conn_01x04
J11
1
Conn_02x12_Counter_Clockwise
J20
1
Conn_02x09_Odd_Even
J21
1
DualDSub
J22
3
1UF
C
C1, C3, C4
1
1UF
1uF
C2

EVOLVER Temperature Calibration Module design files

The KiCad project lives in the FYNCH-BIO/hardware repository on GitHub; these links point at the commit this page was built from.

EVOLVER Temperature Calibration Module: common questions

What microcontroller does the EVOLVER Temperature Calibration Module use?

The EVOLVER Temperature Calibration Module is built around the arduinoChip, from the AVR/Arduino family.

How big is the EVOLVER Temperature Calibration Module?

The EVOLVER Temperature Calibration Module measures 92.7 × 82.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the EVOLVER Temperature Calibration Module?

28 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the EVOLVER Temperature Calibration Module design files?

From the FYNCH-BIO/hardware repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the EVOLVER Temperature Calibration Module design in my own project?

The repository has no license, so all rights stay with FYNCH-BIO. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the EVOLVER Temperature Calibration Module without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in hardware

Similar boards