Rak lora adaptable node breakout-2aa
galopago·rak-lora-adaptable-node-breakout-2aa
About the Rak lora adaptable node breakout-2aa
Rak lora adaptable node breakout-2aa is an open source PCB design by galopago, published on GitHub under the CC-BY-4.0 license. It is a 2-layer board measuring 61.4 × 13.2 mm, with 10 components from 2 distinct parts.
It belongs with the rf & radio, power & battery and dev boards & breakouts designs in this gallery.
From the project
Breakout board for RAK811/RAK4200 LoRa adaptable nodes, small size, used when both AA battery holders were installed.
Breakout board & prototype area to mount a few ( and small ) thru-hole components to interface LoRa node. Also can be used as a template for a custom interface board.
Key features: ------------- Double sided traces and pads for added strength Prototype area with two parallel tracks connecting multiple pads, to be used as a power&ground rails Solder directly to the node's pcb using male header pins for a permanent, rigid and low height card Connect to the node's pcb using male-female pin header combination, for a more flexible solution
Rak lora adaptable node breakout-2aa bill of materials (BOM)
10 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 5 | Conn_01x13_Male | PinHeader_1x13_P2.54mm_Vertical | J1, J2, J3, J4, J5 |
| 5 | Conn_01x11_Male | PinHeader_1x11_P2.54mm_Vertical | J6, J7, J8, J9, J10 |
Rak lora adaptable node breakout-2aa design files
The KiCad project lives in the galopago/rak-lora-adaptable-node-breakout-2aa repository on GitHub; these links point at the commit this page was built from.
Rak lora adaptable node breakout-2aa: common questions
How big is the Rak lora adaptable node breakout-2aa?
The Rak lora adaptable node breakout-2aa measures 61.4 × 13.2 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Rak lora adaptable node breakout-2aa?
10 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the Rak lora adaptable node breakout-2aa design files?
From the galopago/rak-lora-adaptable-node-breakout-2aa repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the Rak lora adaptable node breakout-2aa design in my own project?
Yes, under the terms of its CC-BY-4.0 license, which galopago chose for the repository.
Similar boards
EinkPDA screen
TalismanDesign
95 × 54 mm27 parts2LApache-2.02.0kStack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7kDisplay Carrier
AxxAxx
35.6 × 58.2 mm5 parts2LGPL-3.01.7k88 Pin Vag Breakout
rusefi
142 × 58 mm91 parts2LGPL-3.01.2kBreakout 60pin EEC-IV
rusefi
139.7 × 62.2 mm15 parts2LGPL-3.01.2kEecv breakout
rusefi
140.8 × 53.7 mm9 parts4LGPL-3.01.2k