HardLabs

Dummy cell

iorodeo·potentiostat·hardware/pcbs/dummy_cell/through_hole/dummy_cell.kicad_pcb

Dummy cell PCB layout, top view — open source board by iorodeo
Simulate this board

About the Dummy cell PCB

Dummy cell is an open source PCB design by iorodeo, published on GitHub under the CC-BY-4.0 license. It is a 2-layer board measuring 31.8 × 50.8 mm, with 6 components from 5 distinct parts.

By type, the board carries 3 resistors, 1 relay and 1 capacitor.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

Rodeostat design files, software and firmware

Hardware design, firmware and software for IO Rodeo's Rodeostat Potentiostat.

* Project site: http://potentiostat.iorodeo.com

Designed as a shield for teensy 3.2 development board. 12-bit voltage output with four range settings: +/- 1, 2, 5, 10V 16-bit current measurement with four range settings: +/- 1, 10, 100, 1000 uA ranges Can be programmed over USB using the Arduino IDE (teensyduino). Expansion headers with DIO, analog inputs, UART, I2C, and SPI Schematic

Dummy cell, from the project README
From the project README

Dummy cell bill of materials (BOM)

6 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
VAL**
4-40
1
S1111EC-03
CONN_3
Digikey
K1
1
311-1136-1
C
Digikey
C1
1
311-1.00KCR
R
Digikey
R1
2
P10KDA
R
Digikey
R2, R3

Dummy cell design files

The KiCad project lives in the iorodeo/potentiostat repository on GitHub; these links point at the commit this page was built from.

Dummy cell: common questions

How big is the Dummy cell PCB?

The Dummy cell measures 31.8 × 50.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Dummy cell?

6 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Dummy cell design files?

From the iorodeo/potentiostat repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Dummy cell design in my own project?

Yes, under the terms of its CC-BY-4.0 license, which iorodeo chose for the repository.

More boards in potentiostat

Similar boards