Just making the drone

Jakefeldmanstarosta·just-making-the-drone·v1/hardware/Drone_FC_V1/power.kicad_sch

This repository ships a schematic but no board layout.

About the Just making the drone PCB

Just making the drone is an open source PCB design by Jakefeldmanstarosta, published on GitHub. It is a board, with 15 components from 11 distinct parts.

Other key parts include the XL4015 and AMS1117-3.3. By type, the board carries 8 capacitors, 2 ICs, 2 resistors, 1 connector, 1 diode and 1 inductor.

It belongs with the robotics & motion designs in this gallery.

From the project

The first generation of our drone. This folder contains everything needed to build, fly, and iterate on V1.

The first generation of our drone. This folder contains everything needed to build, fly, and iterate on V1.

Update this table whenever a subsystem moves between in development / integration / flight test / shipped.

- hardware/DroneFCV1/ — KiCad project: schematic (.kicadsch), PCB (.kicadpcb), libraries, backups, datasheets. - firmware/quadflightcontroller.ino — Main flight controller firmware (Arduino). - firmware/v1.ino — Original v1 firmware sketch. - testing/4motorBluetooth.ino — Four-motor Bluetooth bench test sketch. - docs/bom.md — Bill of Materials (canonical parts list). -…

Main components on the Just making the drone

Just making the drone bill of materials (BOM)

15 components, 11 distinct parts.

QtyPartRefs
1
XL4015
U1
1
AMS1117-3.3
U2
1
Conn_01x02
J1
1
D_Schottky
D1
1
L
L1
2
1000uF
C1, C2
4
1uF
C3, C4, C6, C7
1
470uF
C5
1
10uF
C8
1
3k
R1
1
1k
R2

Just making the drone design files

The KiCad project lives in the Jakefeldmanstarosta/just-making-the-drone repository on GitHub; these links point at the commit this page was built from.

Just making the drone: common questions

How many components are on the Just making the drone?

15 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Just making the drone design files?

From the Jakefeldmanstarosta/just-making-the-drone repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Just making the drone design in my own project?

The repository has no license, so all rights stay with Jakefeldmanstarosta. Use it as a reference, and ask the author before reusing the design.

Similar boards