HardLabs

SeizureSync — Seizure Hub

jayis1·Devices·seizuresync/schematic/seizure-hub/seizure-hub.kicad_pcb

This repository ships a schematic but no board layout.

About the SeizureSync — Seizure Hub PCB

SeizureSync — Seizure Hub is an open source ESP32 PCB design by jayis1, published on GitHub. It is a 2-layer board, with 1 components from 1 distinct parts.

Its main chip is the ESP32-S3-WROOM-1-N16R8, from the ESP32 family.

It belongs with the rf & radio designs in this gallery.

From the project

Complex hardware+software device systems that improve daily life for earthlings. Multi-node, full-stack, buildable.

This directory contains the KiCad project files for the SeizureSync Seizure Hub (bedside coordinator node).

Main components on the SeizureSync — Seizure Hub

ESP32-S3-WROOM-1-N16R8

SeizureSync — Seizure Hub bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-S3-WROOM-1-N16R8
SoC dual-core 240MHz 16MB flash 8MB PSRAM
Espressif
U1

SeizureSync — Seizure Hub design files

The KiCad project lives in the jayis1/Devices repository on GitHub; these links point at the commit this page was built from.

SeizureSync — Seizure Hub: common questions

What microcontroller does the SeizureSync — Seizure Hub use?

The SeizureSync — Seizure Hub is built around the ESP32-S3-WROOM-1-N16R8, from the ESP32 family.

How big is the SeizureSync — Seizure Hub PCB?

The SeizureSync — Seizure Hub has 2 copper layers and is 1.6 mm thick.

How many components are on the SeizureSync — Seizure Hub?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the SeizureSync — Seizure Hub design files?

From the jayis1/Devices repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the SeizureSync — Seizure Hub design in my own project?

The repository has no license, so all rights stay with jayis1. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the SeizureSync — Seizure Hub without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards