Fil1

Je0Dev·firstpcbs

Fil1 PCB layout, top view — open source AVR/Arduino board by Je0Dev

About the Fil1 PCB

Fil1 is an open source AVR/Arduino PCB design by Je0Dev, published on GitHub under the CERN-OHL-S-2.0 license. It is a 4-layer board measuring 85 × 52 mm, with 14 components from 7 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the MAX30102 and SSD1306. By type, the board carries 4 resistors, 3 switches, 3 capacitors, 2 ICs, 1 module and 1 diode.

From the project

tutorial pcbs,schematics designs

Fil1, from the project README
From the project README

Main components on the Fil1

Fil1 bill of materials (BOM)

14 components, 7 distinct parts.

QtyPartRefs
1
MAX30102
U1
1
SSD1306
U2
1
Arduino_Nano_v3.x
A1
3
SW_Push
SW1, SW2, SW3
1
LED
D1
3
100n
C1, C2, C3
4
1K
R1, R2, R3, R4

Fil1 design files

The KiCad project lives in the Je0Dev/firstpcbs repository on GitHub; these links point at the commit this page was built from.

Fil1: common questions

What microcontroller does the Fil1 use?

The Fil1 is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Fil1 PCB?

The Fil1 measures 85 × 52 mm, has 4 copper layers and is 1.600198 mm thick.

How many components are on the Fil1?

14 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Fil1 design files?

From the Je0Dev/firstpcbs repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Fil1 design in my own project?

Yes, under the terms of its CERN-OHL-S-2.0 license, which Je0Dev chose for the repository.

Can I test firmware for the Fil1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in firstpcbs

Similar boards